Temecula Auto Repair

After months of postponing travel far away from home, a lot of us can't wait to hit the road and scream "Road Trip!" again.  But how long has it been since the vehicle you're planning on taking has had a thorough inspection? And is it roadworthy for several days on the highway? Time to schedule a professional trip inspection in our service center.  When it comes to long trips, before you go, make sure you can stop.  We can perform a break inspection.  Our technician will visually inspect your brakes for wear and how much life is left in the brake pads and rotors.  They'll also check your brake lines and fluids for fitness and fill. If it's going to be a long trip, it's important that your engine stays lubricated.  The technician will see when the last time you had an oil change, check the levels and inspect the system for leaks.  If you are close to needing an oil change, it's best to have it done before the trip because no one wants to interrupt a va ... read more

Every time you drive your vehicle, you wear down your brakes just a little bit.  And after a while, that adds up.  Gradually, your stopping power isn't like it used to be.  Since brakes are one of your vehicle's most important safety features, it just makes sense to keep them performing well. Most vehicles have disc brakes.  One key component, as the name suggests, is the disc.  Most vehicles have discs on their front and rear wheels.  The discs (also called rotors) are made of metal, and each rotates with the wheel hub.  Your brakes also have pads that make contact with the rotors when you press down on the brake pedal, and the friction stops your vehicle. After many, many stops, that friction wears down both the pads and the discs and reduces their ability to stop the way you need them to.  The discs may also become uneven from all the heat they generate, and your brakes won't stop as well as they used to when they were newer.  Some signs ... read more

You may be fanatical about keeping the outside of your vehicle clean.  But what about what's under the hood? Have you ever thought about how dirt and grime may be affecting your engine's components? One of the most important parts under your hood to keep clean is your vehicle's battery.  With a daily barrage of dirt and moisture, outside parts of your battery can corrode, namely the cables and terminals. Gases vented by batteries can also promote corrosion.  That can create connection problems and affect your vehicle's electrical system.  If corrosion is not cleaned off, it may damage wires and terminals so badly that they will stop properly conducting electricity.  At that point, they may need replacing. When you bring your vehicle to us for a battery inspection and cleaning, we will remove any corrosion and put corrosion-resistant protection on each post. A technician will also visually inspect your battery.  Plus, we can test how much life is in your ba ... read more

Your gasoline engine goes through some exhausting work.  Yes, it's truly exhausting, as in: it produces exhaust! And when your engine starts behaving like it's exhausted, such as running poorly or getting lousy fuel economy, the trouble may be something called a PCV valve. Did you know it's a series of explosions that creates the power in your engine? The spark plugs ignite a mixture of gasoline and air and BANG! A whole bunch of those and you're engine is humming away. Leftover vapors from those explosions go into your crankcase, which is also a place where engine oil goes.  Those vapors still have a lot of unburned fuel in them, and if they had nowhere to go, they'd turn your oil into a thick mess called sludge, not good for a smooth running engine.  Engineers came up with an idea. Re-direct those gasses building up in the crankcase into the engine's air intake and mix them with fresh air.  That way the unburned fuel could go through the engine again and produce p ... read more

Keeping your vehicle's brakes in top shape is one of the most important things you can do for your safety and those on the road with you. Most drivers know a little about brake pads and rotors but maybe not so much about another brake component called the calipers. Disc brakes work by a mechanical system that presses your brake pads against discs called rotors (you can usually see these discs through your wheels). The friction stops your vehicle smoothly when everything is working the way it should.  The calipers use the hydraulic pressure of the brake fluid to apply the stopping power.  After they've been on your vehicle for a while, the calipers can get stuck or wear out.  If calipers on one side of the vehicle work correctly and not on the other, you might feel a pull in one direction.  You might feel the same kind of pull if the caliper is stuck and is applying constant pressure.  You might hear scraping or squealing coming from a stuck caliper and you migh ... read more

Ever wonder how your vehicle’s transmission is connected to your wheels? After all, when you hit a pothole or some other uneven part of a road’s surface, there has to be something that can maintain the connection between the transmission and the wheel yet keep everything moving at the same speed.  That very cool device is called a CV joint, a kind of driveshaft running to each wheel.  The CV stands for constant velocity because it keeps the drive wheels moving at a constant speed (velocity).  They’re used mostly on front-wheel drive vehicles but also in rear-wheel and all-wheel drive vehicles. The joints move up and down and adjust to bumpy surfaces.  Plus, they are covered in a rubber boot which protects them from road debris and also holds lubrication in.  There’s a CV joint and boot on the transmission side and one on the wheel side.  Unfortunately, the spot that usually fails first is that rubber protective cover (the boot).&nbs ... read more

Your vehicle gets its power from burning fuel, usually gasoline, and it counts on something called fuel injectors to send gas to the engine in a spray that is easy to ignite.  It’s a precise operation, and when it’s working well, you have plenty of power and an efficient engine. But after time, contaminants in the fuel system may prevent the injectors from spraying like they’re supposed to.  They can also shoot contaminants into the engine.  One sign that could point to dirty fuel injectors is a misfiring engine. Misfires can be caused by several things, so it’s a good idea to bring your vehicle to us so we can trace the cause. Another sign is that your fuel economy has gone downhill or your engine doesn’t have the “pep” it used to. If we discover that your injectors are clogged or not working the way they should, we can clean them to get rid of those contaminants to restore your engine to its top performance.  When you brin ... read more

When it comes to oil changes, things are really changing.  Most newer vehicles require synthetic oil, and while it costs more than conventional oil, it doesn't need to be changed as often. When conventional oil was the only game in town, you changed your oil every 3,000 miles/5,000 km. But as technology in newer vehicles has rapidly changed, so has oil technology.  Synthetics have been around since the seventies.  Even though they start with a conventional oil base, they are engineered in a chemical processing plant with properties that allow them to keep your engine lubricated at very high temperatures.  They are more uniform and consistent. Synthetic oil doesn't break down as easily, so it lasts longer than conventional oil.  And synthetic oil can flow more easily, even in extremely low temperatures.  As you can see, it has performance advantages at both temperature extremes. Generally, in recent years automakers have been shipping most of their vehicles ... read more

Air conditioning used to be a real luxury in a vehicle, but now it's standard in most.  Your vehicle's air conditioning system is built to last a pretty long time, but like anything mechanical, sometimes it fails.  It helps to know a little about how the A/C works. There's a compressor that pressurizes the refrigerant (you probably recognize the term Freon).  That makes it hotter, so it then goes through a condenser that cools it off.  Then another component takes out impurities and humidity before the Freon goes to a device that makes it lose pressure before it goes to the evaporator.  That's where it gets colder and takes the humidity out of the air. Then your vehicle's ventilation system blows air over the evaporator, cooling the cabin air that gives you such relief on a hot day. Of all these parts, one that does a lot of work is the compressor.  It has to compress that refrigerant and circulate it through the system.  It turns on and off several t ... read more

You probably figured out those shifty letters.  They're what you see on your automatic transmission shifter and stand for Park, Reverse, Neutral, Drive and Low.  Your automatic transmission is one of the great automotive inventions; here are some ways you can keep yours working well. Maintain your transmission regularly.  A technician will check your transmission fluid's level and even its appearance and smell.  If it's dark or has an unusual odor, that could be a sign of trouble. Change from one transmission direction gear into another only when your vehicle is stopped.  So many drivers want to switch from Reverse to Drive quickly or the other way around.  If you do that when the vehicle is moving, you can damage your automatic transmission. Keep your vehicle's cooling system in top shape.  What does the cooling system have to do with the transmission? It helps keep the transmission fluid from overheating.  Follow the manufacturer's recommendati ... read more